ACTIVATED CARBON MSDS

Section I - Substance Identification
Product Name : ACTIVATED CARBON 
Chemical Name : Carbon, Activated Carbon, Activated Charcoal

Section II – Hazardous Ingredients
This material is 100% activated carbon. There are no established PEL, TWA, or TLV values for this material. Caution should be taken for respirable dust. 

The ACCGIH TWA for respirable dust is 2.2 mg/m3. The product has no carcinogenic properties.

Section III - Physical Data
Description : Colorless black solid, granule, pellet or flake/powder
Vapor Pressure : N/A Boiling Point : N/A
Vapor Density : N/A Volatile Percent : N/A
Solubility : Not Soluble Apparent Density : 0.48-0.52 g/cc 
Stability : Stable
Incompatibility : Avoid Contact with strong oxidizers 

Section IV - Health Data
Overexposure Effects : This product is non-toxic through ingestion. It is non-toxic through skin absorption. It is not a primary skin irritant. No sensitization effects are known. It is non-toxic through inhalation. Due to its physical properties, carbon dust may irritate the respiratory system and produce eye irritation. In case of eye contact, flush with water for at least 15 minutes. Contact a doctor immediately. For inhalation, remove the person from the area

Firs Aid : In case of eye contact, flush with water for at least 15 minutes. Contact a doctor immediately. For inhalation, remove the person from the area

Section V – Spill or Leak Procedures
Reportable Quantities : No EPA RQ for this product
If spilled or leaked : Sweep/shovel up and discard or repackage
Waste Disposable Method : Unused carbon may be disposed of in refuse container.

Section VI – Handling & Storage
Protective Gloves : Recommended 
Eye Protection : Safety glasses recommended
Other Protective Clothing : None 
Ventilation : Local exhausts to control dust
Work/Hygienic Practices : Wash thoroughly after handling.
Respiratory Protection : A high efficiency particulate filter is recommended for dust.

Section VII - Special Precautions
Wet activated carbon removes oxygen from air causing a severe hazard to workers in confined spaces. Sampling and work procedures for low oxygen levels should be taken to ensure ample oxygen availability, in accordance with all local, state and federal regulations.